22-Dec-10 – 01:12 by ToddG

50,000 rounds 1 stoppages 1 * ) malfunctions 1 parts breakages

50,000 rounds in just over eight months.

And yes, as many of you have guessed, that is Larry “LAV” Vickers himself shooting #50,000. It seemed only fitting that the man most responsible for the HK45’s existence be there at the end of this incredible test.

Over the course of the entire test, just one single spring broke. The gun is still perfectly reliable and suitable for daily use. Now my wrists and elbows, on the other hand…

In fact, the HK45 had fewer problems at the 50,000 round mark than either of the previous two 9mm test guns, the S&W M&P9 or HK’s own P30! The HK45 truly is bomb proof, especially when you consider that except for two spring change maintenance cycles, every single part in the gun is original. Most companies recommend changing the recoil springs on their 9mm pistols three or four times more often than Heckler & Koch recommends for the HK45.

The HK45 fired its first 31,522 rounds without a bobble of any kind, another pistol-training.com endurance test record. But the mere fact that it out-performed those other pistols tells only part of the story. I do not believe another .45 pistol could fire that many rounds, in that short a time, with that little maintenance, and survive. Anonymous internet chest-thumpers notwithstanding, fifty thousand rounds of full power 230gr ammo through a .45 pistol in eight months is staggering.

(Actually, in fairness, it was only 49,880 rounds of full power 230gr. I did shoot 120rd of ASYM 185gr National Match Target JHP. Do you think that’s what made the difference? Nah, probably not.)

So what are the final numbers:

252 total days of testing

96 trips to the range

average 520.8 rounds per trip

392 hours of range time

average 127.5 rounds per hour

The HK45 was fired in nine States… and one foreign country, eh?

Twelve different types of ammunition from nine different manufacturers were used:

CCI Blazer 230gr FMJ: 26,185

Federal American Eagle 230gr FMJ: 21,354

Remington UMC 230gr MC: 850

Winchester 230gr Ranger SXT: 542

PMC 230gr FMJ: 600

ASYM 230gr FMJ Match: 124

ASYM 185gr National Match Target: 120

Black Hills 230gr FMJ: 50

Mag Tech 230gr MC: 50

Pro Load 230gr Match FMJ: 50

Winchester (white box) 230gr FMJ: 50

Remington 230gr Golden Saber BJHP: 25

The pistol was only cleaned seven times during the entire test, going 10,181 rounds between cleanings at one point.

My final thoughts on the gun:

Shootability: Let’s face it, nothing else matters if you can’t shoot the gun well. The HK45 proved far more performance-oriented than I gave it credit for at the beginning of the test. High bore axis? Not an issue. Heavy recoiling 230gr hardball? No problem. Sub-2 second Bill Drills from concealment? Hell yeah:

Other notable performances:

best F.A.S.T.: 4.14 (clean)

best Triple Nickel: 4.44 (clean) see the video here

see the video here best Hackathorn Standards: 288

best Dot Torture: 50 out of 50 at 10 yards

won the Rangemaster Polite Society Tactical Match

It’s no secret that I have become the King of All Fanboys when it comes to the LEM trigger mechanism. The version found on the HK45 has a little bit of creep but a very short reset (0.15″ by my measurement, the same as a stock Glock). Muzzle flip is very controllable thanks to the extremely good ergonomics, the texture of the so-called “spiderman grip,” and the buffered recoil spring assembly.

Accuracy: It’s always amusing to read people talk about how unimportant handgun accuracy is, or say that Gun-X is “combat accurate” or “as accurate as I am.”

That’s meaningless. Some guns are simply more mechanically accurate than others, and regardless of how accurate a particular shooter may be, the gun is going to add a certain margin of error based on that mechanical accuracy. So while I wouldn’t say handgun accuracy is the most important factor in the world, the fact remains that an accurate pistol will deliver better results — especially on low probability shots — than an inaccurate one.

So how accurate is the HK45? My sample turned in unwavering results from beginning to end. When new, with the stock sights (which are borderline useless), I got an average of 2.22″ groups with Winchester 230gr Ranger SXT. After changing sights, that dropped to 1.80″. After fifty thousand rounds, not to mention thousands of rounds since its last cleaning, did the HK45’s accuracy falter? Not at all. Pictured at left is the 1.39″ group I got shooting that ASYM 185gr ammo (five 5-shot groups averaged 1.85″).

Reliability: There’s almost no way the HK45 could have proven more reliable. Only twice in 50,000 rounds did the gun fail to go through its entire cycle of operation, ready to fire again with nothing more than a trigger pull. Once was a light primer hit, the other was a broken trigger return spring. That’s a Mean Rounds Between Stoppage of 25,000 rounds… ten times the industry standard.

What is perhaps even more amazing is that it achieved that reliability getting cleaned on average less than once every 7,000 rounds. The industry standard for cleaning during endurance reliability testing is once every 250 rounds. So the HK45 went twenty eight times as long without cleaning and still achieved ten times the industry standard for reliability.

The only other incident the gun suffered, as described in great detail here, was a dislodged sear spring. With the spring no longer in place, the gun continued to fire but was stuck in true “double action only” mode with a substantially heavier trigger pull.

Durability: As mentioned above, the pistol had a trigger return spring break during Week Twenty Five, just shy of thirty five hundred rounds into the spring’s service life. It was just a random thing, and proof that no matter who you are and what you’re doing, sometimes springs break.

Keep in mind that except for some springs that were changed at 12,500 round intervals give or take, there were absolutely no parts replacements done during this entire test. Hammer, sear, trigger bar are all original. Extractor is original. Hammer strut is original. Even the pins are original. Nothing broke. Nothing even looks worn out.

And what about the magazines? Almost all 50,000 rounds were fired through the same six practice magazines during the entire test. The mags were dropped on concrete, stepped on in the sand, drowned in muddy water… and never once cleaned or even disassembled. Not a single spring or follower was replaced. They still work 100%. Contrary to internet myth, the zipper welds on the backs of the magazines are also still perfectly fine. And that’s just as true on my carry mags, which remained loaded twenty four hours a day, every day, during the entire test.

That big, over-engineered HK45 is as tough as a handgun could possibly be.

Concealment & comfort: Let’s face it, though, that big, over-engineered HK45 is, well, BIG. This is not a gun that was designed for concealed carry. It’s a battlefield weapon, much more at home in a soldier’s drop leg or a police officer’s duty rig than a thin IWB concealed carry holster.

Nonetheless, carry it concealed I did… and in an appendix IWB, to boot. But holster selection was extremely critical, with the Garrity In-Victus the only holster I could comfortably wear for hours while driving. Even then, the HK45 did not have the same invisible “feels like I’m not wearing anything at all” quality that the P30 does in either an In-Victus or a Custom Carry Concepts Shaggy. The magazines are also bulky, and my spare magazine was often more noticeable underneath my shirt than the pistol itself.

One complaint some folks report with the HK45 is that between the trough in the trigger guard and the large pointy magazine release paddles, they get “stung” when pulling the trigger. This was never a problem for me, but in fairness after almost 100,000 rounds of P30 shooting last year, I might have built up a tolerance!

So while the HK45 is a pistol you can carry concealed if you’re willing to make the effort, that is clearly not what it was designed for and not what it does best.

What would I change?

Clean up the trigger a bit. Less creep, less overtravel. Noted polymersmith David Bowie does an outstanding piece of work called, conveniently, the “Vickers HK45 mods” which include an internal overtravel stop. I did not have this done to the test gun, but if the overtravel bothers you (or some of the other mods are to your liking), it’s a no brainer option.

Compact floorplates. The current floorplates were designed to pass some grueling NATO durability tests. They’re the size of a Volkswagen and not quite as ergonomic. The longer a flootplate’s lip extends past the magazine body, the harder it is to reload well. A more flush-fitting 9rd magazine might not be a bad idea, either.

Usable sights. Flat out, the stock sights are among the worst in the industry. They’re huge, the front sight is wide, the rear notch is narrow, and the “charge to glow” dots are distracting at best (and invisible in the dark unless your prognostication powers allow you to charge them up before trouble starts).

Modular side panels. As well as the HK45 fit in my hand, it was nothing compared to the fully customizable P30. The HK45 would definitely benefit from the replaceable side grip panels found in its 9mm cousin.

Easier assembly. This is a holdover from last year’s P30 experience. The HKs are incredible guns, but if you’re going to detail strip one it helps to have a PhD in Mechanical Engineering. Certain components could be modified into multi-part assemblies that would be more easily dropped into the gun. For example, the two pieces of the LEM hammer and the elbow spring could easily be turned into a single “part” that didn’t rely on gravity and the Force to align properly for assembly.

Nitpicks aside, though, it’s hard to argue with the HK45 as a serious .45 fighting gun. You would be hard pressed to find any gun, in any caliber, capable of delivering the dependability, durability, and shootability of the HK45. This is truly a gun that will withstand far more abuse than its owner could possibly hope to survive, and turn in far greater speed and accuracy than most shooters could ever hope to achieve.

Finally, no pistol-training.com test can end without recognizing all the folks who helped play a role along the way:

HK USA president Wayne Weber , Angela Harrel in public relations, and HK gunsmith extraordinaire Sam Bass (Mgr, HK Repair). HK provided more than just a gun and some ammo for this test. They provided constant access and answers from start to finish without ever trying to influence any aspect of the process.

, in public relations, and HK gunsmith extraordinaire (Mgr, HK Repair). HK provided more than just a gun and some ammo for this test. They provided constant access and answers from start to finish without ever trying to influence any aspect of the process. Melissa Garrett at ATK CCI-Speer/Federal for another year of making impossible to find ammunition appear magically at my doorstep in time for testing.

at ATK CCI-Speer/Federal for another year of making impossible to find ammunition appear magically at my doorstep in time for testing. Mark Garrity of Garrity’s Gunleather for the In-Victus appendix inside-the-waistband holster that was used almost every day of the test.

of Garrity’s Gunleather for the In-Victus appendix inside-the-waistband holster that was used almost every day of the test. Rich Schaefer of Custom Carry Concepts for the Shaggy aiwb holster that I also used from time to time, and the BMC Basic Mag Carriers that were part of my everyday kit whether I was teaching or just doing the CCW thing. Rich also modified some of my HK45 floorplates to make them far more functional in terms of both reload speed and concealability.

of Custom Carry Concepts for the Shaggy aiwb holster that I also used from time to time, and the BMC Basic Mag Carriers that were part of my everyday kit whether I was teaching or just doing the CCW thing. Rich also modified some of my HK45 floorplates to make them far more functional in terms of both reload speed and concealability. The great folks at Heinie Speciality Products for the Slant Pro QWIK Straight Eight night sights that replaced the (nearly useless) stock HK45 sights.

for the Slant Pro QWIK Straight Eight night sights that replaced the (nearly useless) stock HK45 sights. The staff and management at the NRA Headquarters Range in Fairfax, Virginia for their non-stop support as well as their constant vigilance in providing a safe environment in which to shoot for hours on end, week after week.

in Fairfax, Virginia for their non-stop support as well as their constant vigilance in providing a safe environment in which to shoot for hours on end, week after week. Larry Vickers and Ken Hackathorn for taking the time to sit through two hours of questions about their experience with the HK for the upcoming capstone on the HK45 test.

Train hard & stay safe! ToddG

Previous HK45 Endurance Test posts at pistol-training.com: