It has been a dream for a long time to actually have some more usable terrain for my army. Today i used some 4 hours to finish this experimental step.What did i do? The pictures only show three stages, but there have been more. First of all, my new Thermocut comes into play. Using a normal knife i cut some pink foam into rough pieces and made them half their thickness. Those pieces were cut into shapeto look roughly like a stone. The cut pieces were made wet and a filler was massaged by hand into the small pores on the surface. This way a rough appearance is maintained but it isnt looking so porose. I took on some latex gloves to make it easier to clean up afterwards. Once the filler had dried i took a brown color (cheap one off the hardware store) and gave each stone several passes until a even finish had been achieved. The base coat dried out in no time so i proceeded with the next step: Highlighting. Using a "Honeyyellow" color i made the stones look a bit brighter and more like a desert rock (i think it looks like a desert rock).With all the stones dried i assembled them to form the arch and the pillar. They are a bit tricky to stabilize, but it just works out right now. I might have to pin them in the future or make sure the surface in between the stones is as even as possible.And yes, the dimensions are large enough to fit a Vindicator in between and the large surface on top is 6" high, which will make it super difficult or infantry to move there (I might build more arches with varying heights and sizes)With a lot of freetime coming up this page will most likely roar bakc to life for about a month, displaying a wide range of different techniques and builds (Only few warhammer related builds, i asume)