Posted by

Yes, you can do this. It's not rocket science. Repotting is fun. And your orchid will thank you, especially if it's been two or more years since it was repotted. Never repotted an orchid before? We can fix that. Come on into our greenhouse and I'll show you how.A good basic orchid mix consists of equal parts fir bark, charcoal and sponge rock (aka coarse perlite). You can buy these products online fromand. They also sell high quality ready-to-use packaged orchid mixes.: The organic component -in this case the bark- can make or break the quality of an orchid mix, because that's the part that breaks down with repeated watering. The bark should be Douglas Fir or, and should be mold-free.(sold as) and kiln-dried Douglas Fir bark (sold asbark) last longer than regular Douglas Fir bark. Fir bark often needs to be rinsed beforehand in order to remove dust and sediment.The best time to repot an orchid likeiswhen the new shoot is about the length of your pinkie finger. The new shoot indicates that the plant has started a new cycle of growth, the perfect time to provide new roots with fresh medium. We repot every two years, because that's the lifetime of fir bark mixes in our greenhouse. Any longer is asking for trouble -a waterlogged mix that kills roots.: Keep your eye on that new shoot while repotting! It is as fragile as new asparagus and if you break it, you lose an entire season's growth, including the flowers.Keep the new shoot well away from the table when you do this.: Water your plant the day before to make it easier to dislodge.Hold the plant by the pseudobulbs (not the roots!) with one hand and gently prod the mix with your other hand in order to loosen it.: Expect to find new yellow-tipped roots emerging near the base of the new shoot. Be careful not to break them.Healthy roots are white and firm. Dead roots are grey/black and squishy. You can use pruners for cutting, but remember that viruses in plant sap can be spread by using the same tool on consecutive plants.: That's why we use one razor blade per plant. We wrap used blades in duct tape before discarding them. When I divide a large plant, I use a kitchen knife and sterilize it with a propane torch between plants.: Notice the new shoot face up on the table? Don't rest the plant on its new shoot.: Orchid roots can absorb tannins from the bark in the mix and appear brown on the surface. A brown root can be healthy. When in doubt, cut a cross section--a healthy root will have a white core.I like to do this under a gentle stream of water at the sink. It gently removes the old bark hiding in inaccessible places. And it often reveals more dead roots that need to be cut away. If the roots are healthy you don't need to remove all the mix --only about three quarters. If the roots are in poor shape, remove as much old mix as possible.: This is a great time to observe how your plant is constructed. Notice how the vertical shoots (the pseudobulbs) are connected by a horizontal stem (or rhizome, pronounced rye-zome). This will become important in a few minutes.. One inch bigger all around is plenty. Orchids like to attach their roots to their surroundings. Let them.: A step up in pot size isn't always necessary. Sometimes fresh mix and a clean pot of the same size is all that's needed.See how I'm holding the older part of the plant against the rim of the pot? That's because I want the new shoot in the center where it will have plenty of room to grow over the next two years. Looks asymmetric, right? Absolutely. The new shoot goes in the center.Remember to leave the new shoot uncovered.The final soil level should be about a half inch below the rim of the pot. The horizontal rhizome connecting the mature pseudobulbs should be visible just above the soil line.. A rhizome clip is an indispensable part of an orchid grower's tool kit. It's what holds the plant upright and steady while its roots are getting established.: There are two types of rhizome clips. The one above is for clay pots. The other type attaches to the rim of a plastic pot.Placement is important. Lay the straight part of the clip across the top of the horizontal stem (rhizome) between two mature pseudobulbs. Avoid placing it directly behind the tender new shoot. It should be perpendicular to the rhizome and resting on top. Hook the hairpin loop over the rim of the pot.And press down firmly with the heel of your hand.Hey, you're done! Congratulations. All that's left now is to water in your plant. Give it a nice deep drink (and no ice cubes, please) and let it drain.You will probably notice that the new mix dries out faster than the old mix, so it's a good idea to check your plant daily (you do this anyway, right?) to see if it's dry. Give it as much humidity as you can. In a couple of weeks you can resume regular fertilizing. Let me know if you have any questions!