



Threaded rods can be purchased as an add on or the threaded rods can be purchased from most hardware and home improvement stores.



Threaded rod size is 3/8-16 x 24"

Threaded rod size for longer barrels such as the PSL is 3/8-16 x 36"

If you already have the hardware from the AKT010 Barrel Removal/Install tool you can purchase this as an add on "Without brass ram, drive bolt, threaded rods, or nuts". Purchase does not have to be made the same time.



Made in the USA This tool is used to remove the barrel from a bulged AK trunnion and install a barrel into a bulged trunnion that has been riveted to the receiver. The tool kit consists of the following parts: Left and Right Jaws, Bolt Plate, Driving Bolt, Brass Ram, threaded rods, and Nuts. (The PSL and Yugoslavian AK are examples of bulged style trunnions.) If using this tool with a longer barrel such as a PSL you will need to purchase 3/8-16 x 36" threaded rods, these threaded rods can be found in most hoe improvement stores. Note: This tool is the bulged barrel tool and is used for AK rifles with a bulged trunnion. This tool cannont be used with standard trunnions. The front lips on the jaws of the tool are meant for location purposes only, they do not hold the receiver in place while using the tool. The receiver is held in place with clamping pressure, which is achieved with a vise that has parallel jaws and adequate rigidity to clamp the receiver in place. If the trunnion is slipping in the jaws proper clamping pressure is not achieved or your barrel is seized to the trunnion.