● The small outboard leg that is built of aluminum and stainless steel hardware. The only steel used is the drive shaft, clutch

housing and lower unit gears. **No black steel like other vendors and cheap fittings, period.



**There are other vendors selling similiar model designs, but with black steel fittings, pot metal castings, and with inferior engines that won't take the punishment. Honda engines are hands down the best mini 4 strokes money can buy. The other models we carry are built for Kayakbuddys with better fittings and components and are as close as you can get to the real Honda, but with a better price point. Great power and simplicity.



● All of the fittings are stainless as well to extend the longevity of the leg.

● Weighs 23lbs with an engine and 12lbs by itself. No electric trolling motor system can match the torque and rough water

capability from gas propulsion. Runs for roughly 1 hr. on a tank of gas with the throttle fully open using the Honda GX35 engine.

● Upper most mount position to the center axis of the propeller at its maximum height is 23.5 inches.

● You can adjust the vertical trim and lockout of the engine. If an obstacle is struck underwater, the engine will pivot upward with

run unlocked.

● This is a light weight economical way to guide you through the water using small 2 and 4 stroke engines of your choice.

● This is not a flipped around weed eater, but a geared actual drive system that uses a centrifugal clutch system.

● Unlike electric which uses thrust, the gas counterpart works identical to a real boat engine and supplies torque to the prop

through a splined shaft system gear to take advantage of the high rpms. This is why weed eaters fail and burn up.

● Uses a kill switch (deadman style) type. So if you need to shut the engine while fishing or diving this is the most efficient method.

